Copper

This weighted cheek allows for more control and added poll pressure while maintaining clean lateral movement. The cheek pieces are polished steel with decorative copper designs. Ported chain mouthpiece to provide some tongue relief while the chain is light on the bars. Allows for independent rein action.Shank: 6" Mouthpiece: 5 1/4"

Read more less

This is a good bit for the young horse who is ready to be transitioned from a snaffle to a shank bit. The short gag action allows the rider to pick up a horse when needed, allowing for greater control.The three piece smooth dog-bone with a copper roller mouthpiece is comfortable as it lies across the tongue. The smooth bars offer a softer feel. Copper roller provides entertainment for a busy horse and promotes salivation.Mouth: 5 3/4" Cheek: 5 1/2"

Read more less

Shank Level 3: 6-3/4-inch. Mouthpiece Level 3: 1/4-inch Square with copper roller covered dogbone. Gag Length: Unlimited. Unlimited gag slide action with medium-high lift. Leverage gives you speed control, rate, and lateral body posture control at high performance levels. This bit will give you respect without fear and is a game changer for many horses.

Read more less

Attractive, well-balanced shank with medium-plus leverage. The molded mouthpiece bars are comfortable for the horse to carry. Sweet iron and copper create moisture for a softer mouth. The port has slight palate pressure combined with the roller for tongue pressure for a better headset and more control. Copper is a soft metal, watch for excessive wear.

Read more less

Stage B is all about transition, with the introduction of leverage and curb pressure. Short shanked bits and half-gags comprise Stage B.

Read more less

Beautifully designed bit with rasp detail on the cheek.Three-piece mouthpiece allows bit to conform better to the horse’s mouth.Mouth: 5 ¼” Cheek: 6”

Read more less

Myler Flat Shank with Low Medium Wide Port MB 05 with Copper Roller, Level 3 The MB05 is one of the mildest Myler mouthpieces in terms of tongue pressure. The generously wide port allows room for the tongue to pass under the bit. However, unlike the solid MB 33, the MB 05 collapses slightly although it does not fully rotate on to the tongue like a Level 1 or Level 2 mouthpiece. This gives the mouthpiece more give and may apply some light tongue pressure although it works primarily off the lips and bars. The port on this mouthpiece is only 1 ¼"" high, so it will apply little to no palate pressure. Because the MB 05 offers such a high degree of tongue relief, the horse that goes well in this mouthpiece has a trustworthy and consistent disposition, and is trained to work off the leg and seat as well as the hands. Notes: For a slight increase in tongue pressure, see the MB 43LP. For similar tongue relief without Independent Side Movement, see the MB 12. For the same tongue relief and Independent Side Movement, but with no collapse, see the MB 33. For more tongue relief, see the MB 16PB. The 7"" Flat Shank is stainless steel and curved slightly back towards the horse, with a flat-top purchase and a rein ring. The mouthpiece has a fixed attachment. The Flat Shank has the patented Independent Swivel Cheek, where the purchase, mouthpiece and shank all move independently of each other. The purchase is slightly angled away from the cheek to avoid rubbing. It has an indirect (curb) rein action designed to be used with a curb strap which attaches to the purchase. The flat shank uses the combination of the fixed cheek and fixed rein to apply pressure to the mouth, chin and poll. Action: Indirect Discipline: Western Degree of Leverage: Moderate

Read more less

The four moving parts allow the horse to respond to subtle rein pressure which greatly reduces heavy rein handling. This bit can be used in any western discipline.Port: 2", Mouth: 5", Cheek: 7"NOTE: This bit will rust when exposed to moisture. This creates a sweet taste in the horse's mouth and promotes salivation.

Read more less